Free Drain Cleaning with Jolly Home Plan
4.8 Google Rating
Whole-Home Surge Protection in Cincinnati & Northern Kentucky


Summer thunderstorms roll through the Ohio River Valley often, and a lightning strike nearby or a switching event on the utility grid can send a voltage spike through every circuit in your house. A whole-home surge protector installed at your electrical panel diverts that excess voltage to ground before it reaches your furnace, air conditioner, appliances, and electronics.
Contact us to schedule whole-home surge protection with Jolly.

Reasons to Install Whole-Home Surge Protection
Power strips only guard what’s plugged into them. A whole-home surge protector covers the hardwired equipment they can’t reach.
-
Modern equipment runs on circuit boards. Furnaces, heat pumps, AC condensers, refrigerators, and washers all depend on control boards that a single surge can ruin.
-
Many surges start inside the house. Motors in AC compressors, refrigerators, and sump pumps create small surges when they cycle, which wear down electronics over time.
-
Storm season brings bigger spikes. Lightning near your neighborhood can push surges in through power lines, and those spikes are far larger than everyday ones.
-
Power comes back with a jolt. Voltage can spike when power is restored after an outage, right when every appliance in the house tries to start at once.
Whole-Home Surge Protector Installation
A whole-home surge protector, also called a surge protective device or SPD, mounts at or inside your electrical panel and connects to its own breaker. When voltage on the line jumps above a safe level, the device shunts the excess to your home’s grounding system in a fraction of a second, so the spike never travels down the branch circuits to your equipment.
Installation starts with an inspection of your panel and service. A Jolly electrician checks that the panel has room for the breaker the device needs, confirms the panel is in good condition, and tests the grounding and bonding. That last step matters because a surge protector can only send excess voltage to ground if the ground connection is solid. Older homes around Cincinnati sometimes have corroded ground clamps, missing bonding jumpers, or water pipe grounds that were cut during plumbing work, and we correct those before installing the device.
We mount the device with short, direct leads for the best performance and show you its status indicator. Newer editions of the National Electrical Code require surge protection on new and replaced residential services, so if you’re planning electrical panel replacements or a service upgrade, adding the surge protector at the same time saves a second visit.
Panel-Mounted (Type 2) Surge Protectors
This is the most common whole-home option. It installs at the main panel on the load side of the main breaker and protects every circuit fed from that panel.
Service Entrance (Type 1) Protection
A Type 1 device installs ahead of the main breaker at the service entrance and handles larger surges coming in from the utility side. It can be paired with a Type 2 device for homes with expensive equipment or frequent storm exposure.
Point-of-Use Protection for Electronics
A panel device lets a small amount of residual voltage through, so TVs, computers, and home office equipment still benefit from a quality plug-in surge protector.
Grounding and Bonding Corrections
If testing turns up a weak ground or missing bond, we repair it as part of the installation so the surge protector can do its job.
Call Us. We’ll Take Care of It.
Plumbing, drains, heating, cooling, or electrical, we’ll figure out what’s going on and get it handled without making it complicated.Why Choose Jolly for Surge Protection?
Jolly has worked in Cincinnati and Northern Kentucky homes since 1979 and services the heating and cooling equipment that surges damage most often.
-
Electrical and HVAC under one roof. Jolly repairs furnaces, air conditioners, and heat pumps, so we can protect that equipment and service it too.
-
Licensed electricians. Every surge protector is installed by an electrician licensed.
-
Jolly Home Plan. Members get an annual electrical inspection, which is a good time to confirm the surge protector’s status light still shows active protection.
-
Financing available. Surge protection paired with a panel upgrade or standby generator can be paid over time through Jolly’s financing options.
Don’t wait for the next storm to find out which appliance takes the hit. Call now to schedule whole-home surge protector installation with Jolly.

BOGO
Buy an AC System, get a Furnace for FREEExpires: Nov 30, 2026

Contact Us
FAQs
Frequently Asked Questions
Does a whole-home surge protector replace my power strips?
Will a surge protector protect my home from a direct lightning strike?
How long does a whole-home surge protector last?
Should I add surge protection if I have a standby generator?
Call Us. We’ll Take Care of It.
Heating, air, plumbing, electric, drains, or water cleanup, we’ll figure out what’s going on and get it handled without making it complicated